Table of Contents
Advertisement
Required elements
45.4
45.4.1
Access
Description
45.4.2
Availability
Description
Roads - Road
A DTM job is required.
The Toolbox
Overview
Press Fn Tools on any page of the Stake/Check panel.
The toolbox contains additional functionality for each of the stake and check
methods. This functionality is additional to those already existing functions
which are available via the function keys.
The functionality differs between the stake and check methods. Refer to these
subchapters for a detailed description of the functionalities:
"45.4.2 Use heights from DTM"
•
"45.4.3 Apply current chainage"
•
"45.4.4 Get current angle to alignment"
•
•
"45.4.5 Stake individual point"
"45.4.6 COGO Road - Alignment info"
•
"45.4.7 COGO Road - Create points"
•
•
"45.4.8 Additional Layer Info"
"45.4.9 Box / base definition"
•
"45.4.10 Get current slope"
•
"45.4.11 Manual Slope"
•
"45.4.12 Reset slope to design"
•
•
"45.4.13 Shift reference line"
"45.4.14 Recalculate chainage"
•
"45.4.15 Stake intersection point"
•
Use heights from DTM
This menu function is available for the following stake/check methods: Line,
local line, surface grade, crown, layer.
The app offers the possibility to
switch to a height which is retrieved from an existing height layer, as
•
defined in the selected DTM job. The layer from the DTM is applied and
used as a height reference for the staking out or checking of alignments.
retrieve heights from an existing layer, as defined in the DTM job associ-
•
ated with the project. The DTM used is not considered for the stake values.
Three new information lines are added to the
DTM height and DTM layer.
•
show the DTM triangles in the planar view and in the cross section view in
3D viewer.
Once defined, each layer remains active until it is turned off. DTM heights can
be used for both 2D and 3D alignments.
page: DTM height diff,
767
Advertisement
Table of Contents
