Leica Captivate Technical Reference Manual page 228

Scan for Base Station
Channel Settings
228
Protocol Baud rate
12.5 kHz
Satel 8FSK 14400
Satel 16FSK 14400
Satelline 3AS 9600
PCC-4FSK 9600
PCC-GMSK 4800
TrimTalk450s 4800
(P)
TrimTalk450s 4800
(T)
PCC-FST 9600
1
For countries without narrow banding regulations
2
For countries with narrow banding regulations, for example the USA
Next step
Scan to access Scan for Base Station.
This panel provides information about the base stations, with specific types of
devices attached, for example a radio, from which real-time corrections are
being received. This information can also be useful for finding out if anyone
else in the area is using a particular radio channel.
Key Description
OK To select the highlighted base station and to continue with
the subsequent panel.
Channel-1 Available for scanning base stations with radios attached. To
and switch the radio to one channel lower/higher than the cur-
Channel+1 rent channel. The base stations displayed change to broad-
casting on the new channel.
Description of metadata
Metadata Description
- ID of available base stations from which a signal is being
received.
For radios, the base station radios transmitting on the same
channel are listed.
Latency(s) Time delay, in seconds and configured on the base, from
when the base collects the data to when the data is trans-
mitted.
RTK format Format of the data from the base station. Refer to "18.7.1
Configuration of a Rover Real-Time Connection" for more
information about data formats.
Minimum Satel firmware version required:
Baud rate Modulation
25 kHz
28800 8FSK
28800 16FSK
19200 4FSK
19200 4FSK
1 2 GMSK
9600 /NA
GMSK
1 2
9600 /NA
GMSK
1 2
9600 /NA
19200 4FSK
Connections - All other connections,
Use Forward
Error Cor-
rection
OFF
ON
OFF
ON
ON
OFF
OFF
ON
Control Key