Table of Contents
Advertisement
42.8
Description
Access step-by-step
Diagram
Measure corner
612
Field
Option
Easting,
Display only
Northing,
Height
Grid Scan on Plane - TS
Grid scan on plane automates the process of measuring a sequence of points
along the defined vertical, tilted or horizontal reference plane. The window of
interest can be either rectangular or polygonal. The boundaries of the window
of interest and the increment values can be defined. Grid scan on plane can be
run on instruments with the option "reflectorless EDM" only.
1.
After creating or selecting a reference plane, select Grid scan plane
in Grid Scan on Plane.
2.
Press OK.
3.
Choose between:
•
Rectangular area: Two opposite corner points define the rec-
tangular grid scan area. The area must be defined from the first
to the second point. Grid scan areas bigger than 180° are not
allowed.
Polygonal area: Three or more clockwise measured points
•
define the polygonal grid scan area. The polygonal grid scan area
is calculated based on the sequence of the points. Grid scan
areas bigger than 180° are not allowed.
4.
Press OK.
TS_120
For a rectangular grid scan area, measure two points at opposite corners.
For a polygonal grid scan area, measure all corner points in consecutive order.
Key
Description
OK
To either measure another corner point of the grid scan area
or to start grid scanning the area.
Done
For polygonal areas, this key appears for the first time after
the third measured point.
Page
To change to another page on this panel.
Description
Available when Use local plane coordinate
system is not checked in Edit Plane, Origin.
Known
P0 Setup
Unknown
Grid point coordinates
P0
Reference Plane & Grid Scan
Advertisement
Table of Contents
