Table of Contents
Advertisement
Key
Measure
Stop
Store
Near
Page
Fn Settings
Fn Display
Fn Connect
and
Fn Discon-
nect
Fn Tools
Description of fields
Field
Point ID
924
Description
To start logging of static observations. The key changes to
Stop.
To end recording of positions when enough data is collected.
When Automatically stop point measurement is checked
in GS Quality Control, General page, recording of positions
ends automatically as defined by the stop criteria. The key
changes to Store.
To store the point information. When Automatically store
point is checked in GS Quality Control, General page, the
measured point is stored automatically. The key changes to
Measure.
To compare the current position with the coordinates of all
points already stored in the job and find the nearest point.
This point ID is then suggested as the next point ID to be
used.
To change to another page on this panel.
To configure the pages displayed and auto point measure-
ments.
To configure what is displayed in the 3D viewer.
To connect/disconnect from the reference data.
Refer to "37 Apps - The Toolbox".
Option
Description
Editable field
The identifier for manually measured points.
The configured point ID template is used. The
ID can be changed in the following ways:
To start a new sequence of point IDs
•
type over the point ID.
For an individual number independent of
•
the ID template Fn Tools.
Measure - GS
Advertisement
Table of Contents
