Table of Contents
Advertisement
Diagram
Access
☞
☞
908
GS_056
TS_012
If the message panel appears which requires that the app must be activated
using a licence key then refer to "29.3 Load licence keys".
To stake out DTM heights only:
Select Leica Captivate - Home: Stake DTM.
To stake out positions of points and DTM heights:
Select Leica Captivate - Home: Stake pts & DTM.
The positions of points to be staked are stored in the selected design job.
Points which are measured during staking out are stored in the selected job.
Heights to be staked out are taken from the selected DTM job.
The DTM job to be used must be stored in the \DBX directory on the active data
storage device.
Heights without positions are staked out relative to the selected DTM job.
The stakeout procedure is identical as for the normal Stakeout app but the
heights to be staked are taken from the selected DTM job. The negative or pos-
itive height differences from the current position to the equivalent point in the
selected DTM job is calculated and displayed. Height offsets apply.
d2
P1
For GS:
d1
P1 Point to be staked
d1 Cut or fill
d2 Antenna height
d2
P1
For TS:
d1
P1 Point to be staked
d1 Cut or fill
d2 Reflector height
Stakeout
Advertisement
Table of Contents
