Table of Contents
Advertisement
Stake to line - vertical
measurements
Define Stake
588
P3
P0
000244_002
P4
P0
P1
000417_002
This panel is for typing in the stakeout values for a point relative to the line.
The fields available depend on the options chosen in the Settings panel.
Key
Description
OK
To confirm the selections and to continue with the subse-
quent panel.
Stake -/Ch-
To decrease the distance along line/the chainage by Incre-
ment.
Stake +/Ch+
To increase the distance along line/the chainage by Incre-
ment.
Fn Settings
To configure the Measure to line/Stake to line app. Refer to
"41.3 Configuring Measure to line/Stake to line".
Fn Report
To view an alignment report. Refer to " Save Line
Report,Points page".
Fn Start and
To change between the start point and the end point of the
Fn End
line.
P1
For GS:
P0 Start point
P2
P1 End point
P2 Design point
d2
P3 Reference point
d1
d1 Height offset, for
d2 Height offset, for
For TS:
P0 Instrument setup
P2
P1 Start point
P2 End point
P3
P3 Design point
P4 Reference point
d2
d1 Height offset, for
d1
d2 Height offset, for
Measure to line/Stake to line
Height:Start point of line
Height:From line
Height:Start point of line
Height:From line
Advertisement
Table of Contents
