Table of Contents
Advertisement
Horizontal Straight/
Horizontal Curve/
Horizontal Clothoid/
Horizontal Cubic
Parabola/
Horizontal Bloss,
Input page
Roads - Alignment Editor
Key
Description
OK
To accept the panel entries and continue.
Inverse
To calculate the distance and angle between two points from
the job.
Last inv
To select values from the last inverse calculations.
Get point
To apply coordinates or heights from an existing point in the
job. Available when coordinates must be typed in.
Meas app
To go to Measure and measure a point. Available when
coordinates must be typed in.
Page
To change to another page on this panel.
Fn Settings
To configure the Alignment editor app. Refer to "44.3 Config-
uring Alignment Editor".
Fn Reset
To reset all panel entries.
Description of fields
Field
Option
Start chain-
Display only
age
The other fields and options available depend on the Method and Element
type selected in Add Horizontal Element.
For Element type: Straight
Field
Option
Azimuth
Editable field
End chain-
Editable field
age
End easting
Editable field
End north-
Editable field
ing
Description
The end chainage of the start point/previous
element is automatically used and cannot be
edited.
Description
The azimuth displayed is from the previous
element. Another value can be entered man-
ually. Available for Method:Azimuth &
length or Method:Azimuth & end chain-
age.
Chainage at the end of the element. Availa-
ble for Method:Azimuth & end chainage.
Easting for the end chainage. Available for
Method:End coordinates.
Northing for the end chainage. Available for
Method:End coordinates.
715
Advertisement
Table of Contents
