Leica Captivate Technical Reference Manual page 856

Define Points for Set
856
Key Description
OK To measure the entered point and to access Select Points -
Measure.
Done To finish selection of points and access Measure sets of
angles for further steps.
Fn Settings To configure the Sets of Angles app.
Fn Get Pt To select points from the design job.
Description of fields
Field Option
Use precise Check box
target aim-
ing
Use ultra Check box
fine aiming
Automati- Check box
cally meas-
ure points
Next step
IF
new or selected points are to
be measured
existing points are to be
selected
all desired points have been
selected and measured
Description
Available for the 0.5" instruments of TS60.
When this box is checked, four ATRplus
measurements are performed and the mean
value out the measurements is considered
for the angle value.
Reduces the field of view of the ATRplus. The
setting is only applied for Aim at target:
Automatic in Measure & Target.
Available for instruments with automatic aim-
ing and Aim at target:Automatic. If
checked, search and measurements are done
to specified targets in sets.
THEN
OK to access Select Points - Measure.
Fn Get Pt to select a point from the design
job.
Done to return to the previous panel.
Sets of Angles - TS