Leica Captivate Technical Reference Manual page 938

Key
Offset 1
Offset 2
Page
Fn Settings
Fn Display
Description of fields for the default settings
Field
Auto point
ID
Moving
antenna
height
Target
height
Code (auto)
Code
description
Measured
auto points
938
Description
Available when Store points: To DBX (pts&codes) in
Measure Settings, Automatically measure pts page.
To configure recording of the first type of offset points. Refer
to "56.4.2 Configuring Offset Points".
Available when Store points: To DBX (pts&codes) in
Measure Settings, Automatically measure pts page.
To configure recording of a second type of offset points.
Refer to "56.4.2 Configuring Offset Points".
To change to another page on this panel.
To configure auto points. Refer to "56.2 Configuring Auto
Points".
To configure what is displayed in the 3D viewer.
Option Description
Editable field Available unless GS auto points: Date &
time/TS auto points: Date & time in ID
Templates.
The identifier for auto points. The configured
ID template for auto points is used. The ID
can be changed. To start a new sequence of
point IDs, type over the point ID.
Date & time Available for GS auto points: Date &
time/TS auto points: Date & time in ID
Templates.
The current local time and date is used as
identifier for auto points.
Editable field Available for GS.
The antenna height for auto points as
defined in the active working style is sugges-
ted.
Editable field Available for TS.
The target height as defined in the active
settings is suggested.
The point code for the auto point.
No stringing is possible between automati-
cally measured points, even if the code has
the linework functionality assigned.
Depending on the setting for Allow new
codes to be created in Coding, Code &
attributes page, the field is a simple list or a
selectable list and an editable field at the
same time.
Display only The description of the code.
Display only Available after pressing Start. The number of
auto points logged since Start has been
pressed.
Measure - Auto Points