Table of Contents
Advertisement
54.1.2
Requirements
☞
Access
Measure
Measure - GS
Key
Description
Near
To compare the current position with the coordinates of all
points already stored in the job and find the nearest point.
This point ID is then suggested as the next point ID to be
used.
Page
To change to another page on this panel.
Fn Settings
To configure the pages displayed and auto point measure-
ments.
Fn Display
To configure what is displayed in the 3D viewer.
Fn Tools
Refer to "37 Apps - The Toolbox".
Description of fields
Field
Option
Point ID
Editable field
Antenna
Editable field
height
3D quality
Display only
Real-Time Rover Operations
•
A typical working style for real-time rover operations is used.
The appropriate real-time device is attached and working properly.
•
For information on camera and images refer to "32 Camera & Imaging".
For RTK rover:
Select Leica Captivate - Home: Measure.
The fields shown are from a typical working style for real-time rover opera-
tions. The panel described consists of four pages. The explanations for the
softkeys given here are valid for the
Refer to "35 3D viewer" for information on the keys in 3D viewer.
The fields and functionality of this panel vary slightly when accessed from
other apps where individual point measurements are needed.
Description
The identifier for manually measured points.
The configured point ID template is used. The
ID can be changed in the following ways:
To start a new sequence of point IDs
•
type over the point ID.
For an individual number independent of
•
the ID template Fn Tools.
The antenna height as defined in the active
working style is suggested. Changes in the
antenna height do not update the antenna
height as defined in the active working style.
The changed antenna height is used until the
app is exited.
The current 3D coordinate quality of the
computed position.
page and the two user-defined pages.
923
Advertisement
Table of Contents
