Point Codes; Line Id - Leica Captivate Technical Reference Manual

☞
Access
Export
Fbk/Rw5/Raw/Rwd
144
Although the export operation converts any job to an FBK/RW5/RAW/RWD file,
the figure creation is based on existing lines present in the job.
☞ Do not insert "best fit arc" geometry in the linework. CAD packages
do not support "best fit arc" geometry via FBK or RW5 formats. Line
geometry modifications (editing or reversing) that are done after line-
work measurements are only supported by the FBK format.

Point codes

Each point collected should have a point code.
IF you are creating
Autodesk FBK file
TDS RW5 file
MicroSurvey RW5 file

Line ID

IF you are creating
Autodesk FBK file
TDS RW5 file
MicroSurvey RW5 file
Do not remove the data storage device while exporting the data.
From the job menu select Export data\Fbk, Rw5, Raw.
Key Description
OK To export the data.
Fn Settings To configure some format-specific options.
THEN
Point codes are used to match the Description Keys
in Autodesk LDT and Civil 3D to each position loca-
ted.
Point codes are used to generate raw linework in TDS
Foresight.
Point codes are used to match the Description Keys
in MicroSurvey CAD to each position located.
THEN
The figure ID follows the user selection as defined in
the setting menu.
The line IDs are not used when importing data into
TDS Foresight.
The line IDs are not used when importing data into
MicroSurvey CAD 2005.
Job Menu - Export data