Leica Captivate Technical Reference Manual page 660

Field
Stake chain-
age
Slope offset
Slope height
diff
Height dif-
ference rail
Hinge name
Hinge offset Horizontal offset from the hinge point of the slope.
Hinge ht
diff
Additional
line name
Additional
line offset
Additional
line ht diff
Slope
design ratio
Slope dis-
tance hinge
Slope
design ratio
(gon)
Slope
design ratio
(deg)
Slope
design ratio
(%)
Current
slope ratio
Square off-
set
660
Description
Chainage to stake out.
Horizontal offset from the slope.
Height difference from the slope. If no stake height differ-
ence is used Slope height diff = Difference in height.
Height difference from the batter rail to mark the slope (for
Type: Batter rail vertical in Slope Stakeout Settings).
Name of the line defining the hinge of the slope.
Height difference from the hinge point of the slope.
Name of the second line defining the slope.
Horizontal offset from the second line of the slope.
Height difference from the second line of the slope.
Ratio of the slope.
☞
The display format is defined as system setting in
Regional, Slope page.
Slope distance to the hinge point.
☞
All defined settings for a batter rail or reference
point are already taken into account. This value is
the information to write on the stake.
Slope ratio in gon.
Slope ratio in decimal degrees.
Slope ratio in percent.
Ratio of the slope from the current position to the hinge.
☞
For the catch point, the Current slope ratio is
identical to the Slope design ratio.
Offset from the slope, perpendicular to the slope.
Roads - General