Measuring Points By Chainage And Offset; Stake Road; Check Road - Leica Captivate Technical Reference Manual

Stake/Check panel,
3D viewer
45.3.2
Graphical overview
760
3D viewer for Stake shows information about the measured point relative to
the design. The design is defined by the selected layer and line, and the values
entered on the General page.
3D viewer for Check and Stake are similar. Stake contains the Stake view, along
with 2D/3D view, cross section view and navigation view.
For Check and when only a DTM job is used, 3D viewer shows the DTM and the
lines of selected Road layer - always in plan view.
At the top, DTM height and delta height are shown.
☞ Refer to "Stake,pageCheck panel,page" for a description of the icons.
For Stake, extra information is shown at the bottom:
1. Difference in chainage is shown with some footsteps
2. Horizontal offset is shown with some footsteps
3. Height difference is shown as an arrow
4. Current height
5. The element to stake is shown as an orange and green dot
6. The plot can be shown as profile view, plan view, orbital view and
navigation view.

Measuring Points by Chainage and Offset

Stake road

b
e
c
d
Road_034

Check road

f
i
g
h
a
Road_080
b
f
e
c
d
g
a
Roads - Road
h