Leica Captivate Technical Reference Manual page 853

Settings,
Defaults page
Sets of Angles - TS
Field Option
Distance Editable field
tolerance
Next step
Page changes to the Defaults page.
Define the default target properties for points that are added to the point
group by importing.
Description of fields
Field Option
Target Editable field
height
Target Selectable list
Leica con- Display only
stant
Aim at tar- Manually
get
Automatic
With lock
Visibility
Good
Rain & fog
Description
Tolerance for distances.
Description
The default prism height.
Target names as configured in the Targets
panel.
The additive constant as stored for the selec-
ted prism in the Leica Captivate software.
Measurements are done without any auto-
mation. ATRplus search and/or ATRplus
measurement are not performed.
Positioning to static prisms. The ATRplus sen-
sor is used for measurements to static
prisms. If needed, an ATRplus measurement
or ATRplus search is performed after pressing
Measure or Distance.
The instrument locks onto and follows the
moving prism. The ATRplus sensor is used to
follow moving prisms and to find prisms after
loss of lock. Depending on the setting for
Measure distance, single or continuous
measurements are performed. Unavailable
for SmartStation.
Available when a CS20 is connected to a
TS15/TS50/TM50/MS50.
TS16/TS60/MS60 automatically adjust the
settings for optimal performance.
If weather conditions are normal, then select
this mode.
To increase the instrument measuring ability
during suboptimal weather conditions. This
mode is automatically deactivated when the
instrument is turned off.
853