Table of Contents
Advertisement
Define Line,
3D viewer page
Measure to line/Stake to line
Key
Description
Create
To create a line. Refer to "12 Creating Points and Lines".
Shifts
To apply horizontal and vertical shifts to the selected line.
Refer to "Define Shifts". Available for lines only. If using line
segments, shifts are applied in the Define Segment panel.
Page
To change to another page on this panel.
Fn Settings
To configure the Measure to line/Stake to line app.
Fn Report
To view an alignment report. Refer to "Save Line
Report,Points page".
Description of fields
Field
Option
Line
Selectable list
Type
Display only
Length
Display only
Start chain-
Display only
age
Height
Selectable list
From line
User
entered
Start point
of line
DTM
Next step
OK accesses Define Slope, Define Segment, Measure to Line or Define
Stake.
Key
Description
Reverse
To reverse the direction of the lines, so that the distance
along line/chainage increment is in the opposite direction to
the original:
Original:
Description
To select a line. Open the selectable list to
access the Line Selection panel showing all
selectable lines from the design job.
The selected line type as straight, arc or
polyline.
The horizontal grid distance between the
two points of the line.
The beginning chainage of the line.
Depending on the task chosen this parame-
ter determines the design height.
When measuring to a line, it affects the
•
height difference value.
•
When staking, it affects the delta height
value.
Heights are computed along the line.
Heights are typed in manually into the
Height field.
Heights are computed relative to the height
of the starting point of the line.
The height computed from the DTM at the
current position.
Reverse:
577
Advertisement
Table of Contents
