Table of Contents
Advertisement
56.4
56.4.1
Description
Computation of off-
set points
Measure - Auto Points
Field
Option
3D quality
Display only
Slope dis-
Display only
tance
Hz
Display only
V
Display only
Next step
IF
auto points are to be logged
offset points are to be configured
Offset Points of Auto Points
Overview
Offset points
can be created with auto points when auto points are stored to the DBX.
•
can be to the left or to the right of auto points.
•
are automatically computed with the logging of auto points, if configured.
•
•
form a chain relative to the chain of auto points to which they are related.
Subsequent computed chains are independent from each other.
can be coded independently of auto points.
•
•
have the same time of when they were stored as the auto points to which
they are related.
have the same coding functionality, properties and averaging functionality
•
as auto points.
Up to two offset points can be related to one auto point.
The panels for the settings of offset points are identical except for the title
Auto Points - Offset 1 and Auto Points - Offset 2. For simplicity, the title
Auto Points - Offset 1 is used in the following description.
The computation of offset points depends on the number of auto points in
one chain.
One auto point
No offset points are computed or stored.
Description
Available for GS.
The current 3D coordinate quality of the
computed position.
The measured slope distance.
When Start is pressed, Measure dis-
tance: Continuously is set and the slope
distance is constantly updated.
The current horizontal angle.
The current vertical angle.
THEN
Start. Then, for Measure new point
after certain: Key press, Measure
whenever you want to log an auto
point.
Offset 1 or Offset 2. Refer to
"56.4 Offset Points of Auto Points".
939
Advertisement
Table of Contents
