Leica Captivate Technical Reference Manual page 575

Settings,
TS specific page
Measure to line/Stake to line
Field Option
Design east-
ing
Design
North
Design
height
For slope only also available
Current
slope ratio
Slope
design ratio
Slope dis-
tance to
hinge
Slope dis-
tance to
line
Height dif-
ference to
slope
Hinge offset Displays the horizontal offset from the hinge
Hinge
height diff
Next step
Page changes to the TS specific page.
Description of fields
Field Option
Do not Check box
update
stakeout
values
between
distance
measure-
ments
Automati- Check box
cally aim
instrument
to point
being
staked
Automatic
behaviour
Description
Displays the Easting of the design point.
Displays the Northing of the design point.
Displays the height of the design point,
depending on the defined heights to use.
Displays the ratio of the slope from the cur-
rent position to the hinge.
Displays the defined ratio of the slope from
the design point to the hinge.
Displays the slope distance offset from the
hinge to measured point.
Displays the slope distance offset from line
to measured point.
Displays the height difference between the
current position and the height of the slope
at that position. A cut is above the slope. A
fill is below the slope.
point of the slope to the current position.
Displays the height difference from the hinge
point of the slope to the current position.
Description
When this box is checked, angles and stake-
out values are updated after a distance was
measured. Then all values are frozen until
the next distance is taken.
When this box is checked, the instrument
positions automatically to the point to be
staked.
Available when Automatically aim instru-
ment to point being staked is checked.
575