Inspect Surfaces; Accessing Inspect Surfaces - Leica Captivate Technical Reference Manual

60
60.1
Description
Activating the app
60.2
Access
Define Reference Sur-
face
978

Inspect Surfaces

Overview
The app can be used to compare two surfaces.
The surfaces can be defined by scans, points, planes or solid.
The result is displayed in a map but can be shown as statistics, exported as
report or exported as surface.
If the message panel appears which requires that the app must be activated
using a licence key then refer to "29.3 Load licence keys".

Accessing Inspect surfaces

Select Leica Captivate - Home: Inspect surfaces.
Define the reference surface to which another surface is compared to.
Key Description
OK To select the highlighted option and to continue with the
subsequent panel.
Fn Settings To configure the app. Refer to "60.3 Configuring Inspect sur-
faces".
Description of options
Option Description
By scanning Available in TS mode.
a new sur-
face
From exist- Available when surfaces exist in the job.
ing scans To create a reference surface from existing scans in the
selected job.
From exist- To create a reference surface from points in the selected job.
ing points
From a pre- Select from:
defined Horizontal plane
•
plane or Choose or measure a point to define the height of the
solid horizontal plane.
Vertical plane
•
Choose or measure two points to define the orientation
of the vertical plane.
Plane defined by three points
•
Choose or measure three points to define the plane.
Cylinder
•
Choose or measure two points to define the axis of the
cylinder and enter the radius of the cylinder.
Cone
•
Choose or measure two points to define the axis of the
cone, and enter the radius for the two bases.
Inspect Surfaces