Table of Contents
Advertisement
47.4.2
Description
Availability
Access
Stake Face Auto,
General page
Roads - Tunnel
Stake face auto
To stakeout tunnel face points automatically. The surveyor configures and
selects the points to use in the stakeout. The person driving the drilling
machine can see the stakeout points looking to the current position of the
laser.
This menu function is available for the stake method Stake face.
This menu option is available if the defined chainage has a valid value.
Measure distance: Continuously is supported.
1.
Press Fn Tools in Stake Face.
2.
Select Stake Face Auto in Stake Face Tools.
Key
Description
OK
To access the Stake Face Auto panel.
Page
To change to another page on this panel.
Description of fields
Field
Option
Store
Check box
staked
points
Wait time
Check box
after staked
point
Delay
Editable field
Verify orien-
Check box
tation
Orientation
Selectable list
job
Orientation
Selectable list
point
Hz tolerance Editable field
Description
When this box is checked, the staked points
are stored.
When this box is checked, a time delay is
active after staking a point and before stak-
ing the next point starts.
The time delay after staking a point and
before staking the next point starts. Available
when Wait time after staked point is
checked.
When this box is checked, the system checks
orientation automatically in a defined inter-
val. If the orientation error is greater than
the defined Hz tolerance, then the auto
mode is stopped.
A point for the orientation check can be
selected from a job on a data storage device.
Available when Verify orientation is
checked.
The point ID of the point for the orientation
check. Available when Verify orientation is
checked.
Tolerance for horizontal directions. If the ori-
entation error is greater than the defined
angle, then the auto mode is stopped. Avail-
able when Verify orientation is checked.
835
Advertisement
Table of Contents
