Leica Captivate Technical Reference Manual page 884

Key
GS
Done
Calculate
Fn Find
Fn Position
Description of fields
Field
Point ID
Target
height
Angle right
V angle
Slope dis-
tance
Difference
in horizon-
tal distance
Difference
in height
884
Description
Applicable when using SmartPole. To enter the Measure
panel and measure a point with GS. The antenna height is
automatically converted from the target height.
For Resection only. To exit the Setup app temporarily. The
setup is incomplete but can be continued later. This softkey
changes to Calculate when sufficient data is available.
For Multiple backsights:
Available after the first measurement. You can see the calcu-
lated setup orientation and other results.
For Resection:
Available after measuring two target points or as soon as a
preliminary setup and orientation can be calculated. The cal-
culated setup coordinates and overall "quality" of the results
are displayed.
For Orientate to object:
Available after measuring three or more target points. The
calculated setup coordinates and overall "quality" of the
results are displayed.
Stakeout values are provided to guide the prism holder to
the selected target point.
For Resection and Orientate to object, this key becomes
available once sufficient data is available for calculation.
Refer to "50.8 Finding a Target Point".
To position the instrument to the selected target point.
For Resection:
Available once sufficient data is available for calculation.
Option Description
Selectable list The point ID of the target point to be meas-
ured.
Editable field The height of the target above or below the
backsight point. The last setup target height
is always remembered.
Display only Available when Hz angle display: Angle
right is configured in Regional, Angle page.
Displays the horizontal angle difference
between the backsight point and the current
telescope position.
Display only The current vertical angle.
Display only The measured slope distance after Distance
was pressed.
Display only The difference between the calculated and
the measured horizontal distance.
Display only The difference between the given and the
measured height of the target point.
Setup - TS