Table of Contents
Advertisement
49
49.1
Description
☞
Diagram
Sets of Angles - TS
Sets of Angles - TS
Overview
Sets of Angles:
This app is used to measure multiple sets of directions and distances
•
(optional) to pre-defined target points in one or two faces.
•
The mean direction and mean distance (optional) to each target point,
within a set is calculated. The residual for each direction and distance
(optional) within a set is also calculated.
•
The reduced average direction and average distance (optional) to each tar-
get point, for all active sets is calculated.
Coordinates to each target point are calculated using the reduced average
•
direction and average distance (optional).
Monitoring:
•
This module is integrated within the Sets of Angles program.
With this module, it is possible to use a timer to enable repeated and
•
automated angle and distances measurements to pre-defined target
points at defined intervals.
If the message panel appears which requires that the app must be activated
using a licence key then refer to "29.3 Load licence keys".
P1
P2
P3
P0
TS_048
Known:
P1 Pre-defined target point - E,N,Height (optional)
P2 Pre-defined target point - E,N,Height (optional)
P3 Pre-defined target point - E,N,Height (optional)
P4 Pre-defined target point - E,N,Height (optional)
P5 Pre-defined target point - E,N,Height (optional)
Unknown:
a
Mean direction and mean distance (optional) to each target point,
within a set
b
Mean coordinates (optional) for each target point, for all active sets
c
Residual for each direction and distance (optional ), within a set
d
Reduced average direction and average distance (optional) to each
target point, for all active sets
P5
P4
849
Advertisement
Table of Contents
