Apply Current Chainage; Get Current Angle To Alignment - Leica Captivate Technical Reference Manual

Use Heights From
DTM
45.4.3
Availability
Description
45.4.4
Availability
Description
768
Key Description
OK To confirm the settings and return to the Stake/Check panel.
Description of fields
Field Option
DTM Display only
DTM layer Selectable list
Use DTM Check box
height for
stake out
Show DTM Check box
height dif-
ference on
Info page
tab
DTM layer Selectable list

Apply current chainage

This menu function is available for all stake methods except layer.
To set Stake chainage on the
age.

Get current angle to alignment

This menu function is available for the stake/check of lines and local lines.
To project a measured point to the alignment considering the entered Stake
chainage. This functionality is only available when Use non-perpendicular
offset is checked in the Stake panel on the
Description
DTM from the selected DTM job.
When selecting a DTM layer the relevant tri-
angle of the DTM is shown in 3D viewer.
When this box is checked, a layer of the DTM
is used as a height reference.
When this box is not checked, no DTM
heights are applied for stakeout or check.
When this box is checked, a layer of the DTM
to be used as a height reference on the
page.
When this box is not checked, no additional
height information relative to the DTM is
shown on the page.
Available when Show DTM height differ-
ence on Info page tab is checked. Layer of
the DTM to be used as a height reference.
When selecting a DTM layer the relevant tri-
angle of the DTM is shown in cross section
view in 3D viewer.
page of the stakeout to the current chain-
page.
Roads - Road