Table of Contents
Advertisement
58.10
58.10.1
Description
☞
Access
Traverse Adjustment,
Method page
962
Traverse Adjustment
Accessing Traverse Adjustment
•
A traverse adjustment can be performed on three components: 2D posi-
tions, angles and elevations.
Various adjustment methods are available for selection. Once the adjust-
•
ment is performed, the results can be reviewed. Adjusted points are stored
into a new job, and a report can be generated.
•
If the message panel appears which requires that the app must be activa-
ted using a licence key then refer to "29.3 Load licence keys".
Survey points have to be measured while Traverse is running to be part of the
adjustment calculations.
The traverse adjustment option can be reached in different ways based on spe-
cific conditions.
Upon completing the observations onto the closing point, Adjust to access
Traverse Adjustment.
OR
After the measurements are done on the closing line for angular closure,
Adjust to access Traverse Adjustment.
OR
When the traverse is closed: Result in Traverse Data, then Adjust in Tra-
verse Results to access Traverse Adjustment.
Key
Description
OK
To calculate the result.
Page
To change to another page on this panel.
Fn Settings
To configure the Traverse app. Refer to "58.6 Configuring
Traverse".
Description of fields
Field
Option
Traverse ID
Display only
Horiz
Compass
adjustment
rule
Description
The ID of the traverse.
Suitable for surveys, where angles and dis-
tances were measured with equal precision.
Traverse
Advertisement
Table of Contents
