Table of Contents
Advertisement
Settings,
Quality control page
570
Description
Especially when checking points it is useful to enable the Quality control cri-
teria available. For every point stored, the chosen parameters are checked.
When Quality control criteria is fulfilled, the difference icons are turning
green, and the measured point can be directly stored. If the check limits are
exceeded a warning is shown. This function guarantees a higher productivity as
it is no longer necessary to check the values for every shot taken.
Description of fields
Field
Option
Check dif-
Check box
ferences
before stor-
ing
Differences
to check
Chainage,
offset &
height
Chainage &
offset
Position &
height
Position
Height
Chainage
From 0.001
limit
to 100
Offset limit
From 0.001
to 100
Position
From 0.001
limit
to 100
Height limit
From 0.001
to 100
Next step
Page changes to the Heights page.
Description
When this box is checked, a position check is
done when storing a staked point. When the
defined tolerance is exceeded, the stakeout
can be repeated, skipped or stored.
When this box is not checked, no quality
check is done during stakeout of points.
☞
Depending on this selection the
following lines are enabled/disa-
bled.
Check for chainage, horizontal offset and
height.
Check for chainage and horizontal offset.
Check for 2D position and height.
Check for 2D position.
Check for height.
Maximum difference in chainage.
Maximum horizontal offset from defined
position.
Maximum radial horizontal distance.
Maximum height difference.
Measure to line/Stake to line
Advertisement
Table of Contents
