Leica Captivate Technical Reference Manual page 571

Settings,
Heights page
Settings,
Design page
Measure to line/Stake to line
Description of fields
Field Option
Allow edit- Check box
ing the
height of
the location
being
staked
Next step
Page changes to the Design page.
On this page, additional design points to be staked are set. Refer to "41.6
Staking to a Line" for a graphic.
Description of fields
Field Option
Project to Check box
segment of
stake posi-
tion
Segment to Back or
use at Angle Forward
Points
Horizontal Check box
(PC, PT, AP)
Mid curve Check box
(MCP)
Curve radius Check box
(RP)
Offset Check box
bisected
point (BP)
Offset in Check box
average
direction
(Avg)
Vertical Check box
(VPI, Low,
High, VPC,
VPT)
Description
When this box is checked, the design height
can be changed manually for Height: From
line or Height: Start point of line.
Description
When staking on offset line based on a poly-
line, there are situations where no valid off-
set information can be calculated and dis-
played. This situation appears at offset bisec-
ted points (BP).
When this box is checked, a line is defined to
orientate to so that stake values can be cal-
culated and displayed.
Refer to "Points of interest" for a diagram
showing angle points.
Defines if the segment used as reference for
the stakeout values is in backwards or for-
wards direction.
Horizontal type points occur at the junction
between two segments in a line.
Occurs in arc segments.
Occurs in arc segments.
Occurs when the junction between two seg-
ments in a line is not tangent AND when off-
sets are active.
Occurs when the junction between two seg-
ments in a line is not tangent AND when off-
sets are active.
Vertical type points occur at the junction
between two segments in the vertical align-
ment of the line, or when a high or low ele-
ment is found. Example: In a curve between
two grades
571