Table of Contents
Advertisement
58.7.3
Close traverse step-
by-step
956
11.
A confirmation window is displayed.
Move to move to the next setup.
12.
Repeat steps 1. to 11. until traverse is ready to be closed.
Closing Traverse
1.
Refer to paragraph "58.7.2 Continuing an Existing Traverse" to meas-
ure a traverse. Measure a backsight on a new setup.
2.
The confirmation window in Forsght, Set: is displayed.
Close to begin the process for closing the traverse.
3.
The confirmation window to select a known point is displayed.
OK
4.
The job panel for the design job is displayed.
Highlight the closing point.
5.
OK to select the highlighted point.
6.
Forsght, Set:
Measure to measure and record the closing point.
7.
Point Results
OK to view traverse results.
8.
Traverse Results
OK to display the confirmation window.
9.
C ang to close the traverse with angular closure.
☞
Optionally the traverse can be adjusted.
10.
Move to the closure point and start Traverse app.
11.
Traverse
Select Choose an existing traverse.
12.
OK to access Existing Traverse.
13.
Existing Traverse
Traverse ID The name of the traverse to be closed is displayed.
14.
OK to access Close Angle.
15.
Close Angle
Closing method To measure onto a known point or a known azi-
muth.
Foresight ID The point ID of the foresight point.
Known azimuth Available for Closing method : By known azi-
muth. Known azimuth for foresight point.
16.
OK to access Backsight, Set:.
17.
Measure to measure all sets.
18.
Point Results
OK to view traverse results.
19.
Traverse Results
OK to exit viewing traverse results.
20.
Exit to quit the Traverse app.
Traverse
Advertisement
Table of Contents
