Table of Contents
Advertisement
15.2
TS Connection Wizard
164
IF
a MS60/TS60 is connected
using cable and a software
other than Leica Captivate is
running on the field control-
ler
connected using Bluetooth
connected using WLAN
Connection Using TCPS
This panel is valid for TCPS27/TCPS28/TCPS29.
☞
The channel on which the TCPS broadcasts can be changed. Changing channels
changes the frequency at which the TCPS operates. This may be necessary to
enable multiple pairs of TCPS to work simultaneously in the same area without
interfering with each other.
Key
Description
Back
To return to the previous panel.
Next
To confirm the settings and to continue to the next panel.
Fn Default
To return the fields back to their default values.
Fn Save
To save the settings.
Description of fields
Field
Option
Radio type
Display only
Link number
Editable field
Set as
Remote or
Base
THEN
for a serial connection refer to "15.3
•
Connection Using Cable".
•
for a USB connection, the system sets all
the parameters to be able to connect to
a CS using USB interface from port 1.
Next changes to the next panel.
The Bluetooth connection is established
automatically.
Press Finish.
enable and configure WLAN within WinCE.
Next changes to the next panel.
Press Finish.
Description
The type of protocol.
The assigned channel number.
The TCPS inside the field controller and the
TS16/MS60/TS60 must be set to opposite
settings. Set the field controller to Remote
and TS16/MS60/TS60 to Base.
Connections - CS connection wizard
Advertisement
Table of Contents
