Leica Captivate Technical Reference Manual page 880

Key
GS
Store
More
Page
Fn Run /
Indiv ID
Description of fields
Field
Backsight ID
Target
height
Direction
Horizontal
distance
Slope dis-
tance
Difference
in height
Computed
direction
Computed
horizontal
distance
880
Description
For Set orientation:
A distance measurement is NOT required when setting the
setup and the orientation with Set.
For Known backsight applicable when using SmartPole. To
enter the Measure panel and measure a point with GS. The
antenna height is automatically converted from the target
height.
To store the measurement with or without a distance. Only
available when Use two face measurements is selected in
the Setup settings.
To change between the slope and the horizontal distance.
To change to another page on this panel.
Available for Setup method: Set orientation only.
Run automatically chooses the next available point ID from
the list of points already stored.
Indiv ID to type in any value for Backsight ID.
Option Description
Point ID of the backsight point.
Editable field For Set orientation.
Selectable list For Known backsight. Select a point from
the points stored in the design job.
Editable field Height of the target above or below the
backsight point. The last setup target height
is always remembered.
Editable field Available for Set orientation. The direction
is set to 0 by default. This value can be edi-
ted. The value is not set to the system until
Set is pressed.
Display only Available for Set orientation. Press Dis-
tance to measure a distance to the target
point being used to set the azimuth.
Display only Available for Set orientation. The slope dis-
tance measured between the setup point
and the backsight point.
Display only Available for Set orientation. The vertical
distance between the setup point and the
backsight point.
Display only Available for Known backsight. Displays the
calculated azimuth from the selected setup
to the backsight point.
Display only Available for Known backsight. Displays the
calculated horizontal distance between the
selected setup and backsight point.
Setup - TS