Measure to line - arc
segment - vertical
measurements
☞
Measure to Line,
page
Measure to line/Stake to line
P3
P0
GS_024
P4
P0
P1
TS_030
Design point outside the range of the selected element:
When measuring outside of the defined lines, lines and arcs are extended in a
straight projection tangent to the start/end of the line. For Height: From line,
the start/end grade of the line is also extended. A warning appears when this
is the case.
When working with segments, the same extension rules are applicable to the
selected segment beyond its limits. For lines imported from a road alignment,
heights are not extended outside the segment.
An additional page is available when a user-defined page is used.
Key
Description
Measure
For GS:
To start measuring the point being staked. The key changes
to Stop. The difference between the current position and
the point being staked is still displayed.
Measure
For TS:
To measure a distance and store distance and angles.
P1
P2
For GS:
P0 Start point
d2
P1 End point
d1
P2 Measured point
P3 Reference point
d1 Difference in height
d2 Line height difference
P2
For TS:
P0 Instrument setup
P3
P1 Start point
P2 End point
d2
P3 Measured point
d1
P4 Reference point
d1 Difference in height
d2 Line height difference
585