Table of Contents
Advertisement
Stake Points,
page
590
Field
Option
Only for
Editable field
curves
under a
radius of
Next step
OK to accept changes and continue to Stake Points.
Once in the Stake Points panels, the user is guided to reach design positions.
The functionality of this panel is similar to the Stake Points panel. Differences
between the two panels are outlined here. Refer to paragraph "51.4 Staking
Out" for all other key and field explanations.
In the title bar is a description of where the stake point is on the alignment.
This description can come from the position of the defined stake point along
the line or a point of intersection. For points of interest, refer to "Points of
interest".
The availability of the fields depends on the settings in Settings, General
page.
Key
Description
Stake -/Ch-
To decrease the distance along line/the chainage by Incre-
ment.
Stake +/Ch+
To increase the distance along line/the chainage by Incre-
ment.
Fn Tools
Refer to "37 Apps - The Toolbox".
Description of fields
Field
Option
Point ID
Editable field
Target
Editable field
height
Description
Available when Use different increment on
curves is checked. Defines the threshold
value of a small radius curve. For example, a
curve with a radius smaller than this value,
uses the chainage increment defined in the
following field.
Description
The point ID of the point to be staked.
For TS:
The last used target height as defined is sug-
gested. An individual target height can be
typed in.
Measure to line/Stake to line
Advertisement
Table of Contents
