Table of Contents
Advertisement
Stake Track,
page,
Check Track,
page
Roads - Rail
Information regarding the measured point can be entered. This panel allows
any point of the track to be checked against design values.
Key
Description
Measure
For GS:
To start measuring the point being staked. The key changes
to Stop.
For TS:
To measure a distance and store distance and angles.
Stop
For GS:
To end measuring the point being staked. When Automati-
cally stop point measurement is checked in GS Quality
Control, General page recording of positions ends automat-
ically as defined by the stop criteria. The key changes to
Store. After ending the measurements, the differences
between the measured point and the point to be staked are
displayed.
Store
For GS:
To store the measured point. When Automatically store
point is checked in GS Quality Control, General page, the
measured point is stored automatically. The key changes to
Measure.
For TS:
To store angles and distance. Distance must be measured
before.
Distance
For TS:
To measure a distance.
Ch -
Available for Stake rail. To decrease the chainage as defined
by Chainage increment.
Ch +
Available for Stake rail. To increase the chainage as defined
by Chainage increment.
Page
To change to another page on this panel.
Fn Settings
To configure the app. Refer to "43.3 Configuring Roads
Apps".
Fn Position
For TS:
To position the TS to the defined stakeout point, including
defined offsets. The settings for Rail Settings in Road Set-
tings, TS specific page, apply. Refer to " Road Settings,TS
specific page".
Fn Tools
To access the toolbox. Refer to "46.4 The Toolbox".
799
Advertisement
Table of Contents
