Table of Contents
Advertisement
Point ID,
Annots page
Point ID,
Mean page
7.3.3
Description
Averaging
88
stored for this point code in the active codelist. Suggested attribute values:
Default shows the default attribute values for this point code if existing.
☞
It may happen that a point with the same point ID exists in the job. If
the codes and/or attribute values of the new and the existing point
do not match, a panel opens where they can be corrected.
Next step
Page changes to the next page.
Available when the edited point is Class: Navigated or Class: Measured and
no offset point.
The comments to be stored with the point can be edited.
Next step
Page changes to the next page.
Available when the edited point is Class: Average.
Refer to "7.3.3 Mean Page" for a detailed description.
Mean Page
In order to check measurements, the same point can be measured more than
once.
These measured points are assigned the class Measured. The various meas-
ured coordinate triplets for one point can be recorded using the same point ID.
If the Duplicate points mode is activated, an average is calculated when more
than one measured coordinate triplet is available for the same point ID.
The averaged point is given the class Average. It is checked if the deviations
of each single point are within the limits configured in Duplicate Points.
After averaging, the Mean page becomes available when editing the point and
accessible from the Measure app. Available functionality on the Mean page
depends on the selected Duplicate points mode.
Defining the mode and configuring the limits
The mode and the limits are configured in Duplicate Points.
Description of modes
Mode
Check the average
Description
When more than one measured coordinate triplet is
recorded for the same point, the average for the
position and the height is computed. Depending on
the selected method, the average is computed
weighted or arithmetic (no weighting). The class
Average is assigned to the averaged point.
Job Menu - View & edit data
Advertisement
Table of Contents
