Table of Contents
Advertisement
34
34.1
☞
☞
☞
Select the Internet
interface
Configure the Inter-
net interface
NTRIP via Internet
NTRIP via Internet
Configuring Access to the Internet
Configure an Ntrip connection using the RTK Rover Wizard. Select Leica Cap-
tivate - Home: Settings\Connections\RTK rover wizard and follow the on-
panel instructions.
The remainder of this chapter describes each of the steps and panels when
configuring without the use of the RTK Rover Wizard.
For TS: One Internet interface is available - the CS internet.
For GS: Two Internet interfaces are available - the CS internet and the GS
internet.
The CS internet is used as an example. The explanations are also valid for the
GS internet.
To access the Internet with a GS or TS instrument, General Packet Radio
System devices are normally used. GPRS is a telecommunication standard for
transmitting data packages using the Internet Protocol (IP).
Select Leica Captivate - Home: Settings\Connections\All other connec-
tions.
On the CS connections page highlight CS internet.
Press Edit.
1.
Select a port (Connect using).
2.
Select a device (Device).
3.
If necessary, enter User ID and Password. Some providers ask for a
User ID and a Password to allow connecting to the Internet using
GPRS. Contact your provider if user ID and password are required.
4.
OK to return to Connection Settings.
5.
In Connection Settings press Control. Continue with the next
paragraph.
401
Advertisement
Table of Contents
