Measure - Gs; Measuring Points; Post-Processed Kinematic And Static Operations - Leica Captivate Technical Reference Manual

54
54.1
54.1.1
Requirements
☞
Access
Measure
922

Measure - GS

Measuring Points

Post-Processed Kinematic and Static Operations

A typical working style for a static or post-processed kinematic operation is
used. Ensure that the working style has GNSS Raw Data Logging selected in
the GNSS Raw Data Logging panel.
For information on camera and images refer to "32 Camera & Imaging".
For RTK rover:
Select Leica Captivate - Home: Measure.
☞ If configured for post-processed kinematic operations, the logging of
moving observations begins.
The fields shown are from a typical working style for static or post-processed
kinematic operations. The panel described consists of four pages. The explana-
tions for the softkeys given here are valid for the
defined pages. Refer to "35 3D viewer" for information on the keys in 3D
viewer.
The fields and functionality of this panel vary slightly when accessed from
other apps where individual point measurements are needed.
Key Description
Measure To start logging of static observations. The key changes to
Stop.
Stop To end recording of positions when enough data is collected.
When Automatically stop point measurement is checked
in GS Quality Control, General page, recording of positions
ends automatically as defined by the stop criteria. The key
changes to Store.
Store To store the point information. When Automatically store
point is checked in GS Quality Control, General page, the
measured point is stored automatically. The key changes to
Measure.
page and the two user-
Measure - GS