Leica Captivate Technical Reference Manual page 643

Road Settings,
TS specific page
Roads - General
Field Option
Next step
For TS: Page changes to the TS specific page.
For GS: Page changes to the Report sheet page.
Description of fields
Field Option
Do not Check box
update
stakeout
values
between
distance
measure-
ments
Description
Define which parameters are viewed on each
line. Up to 16 lines of parameters can be
defined.
The available parameters depending on the
Method selected are explained separately:
For Road Line, refer to "43.3.2 Road
•
Line - Info Page".
For Road Local line, refer to "43.3.3
•
Road Local Line - Info Page".
For Road Surface grade, refer to "43.3.4
•
Road Surface Grade - Info Page".
For Road Manual slope, Local manual
•
slope and Slope, refer to "43.3.5 Road
Manual Slope, Local Manual Slope and
Slope - Info Page".
For Road Crown, refer to "43.3.6 Road
•
Crown - Info Page".
• For Road Layer, refer to "43.3.7 Road
Layer - Info Page".
For Road DTM, refer to "43.3.8 Road
•
DTM - Info Page".
• For Rail refer to "43.3.9 Rail - Info Page".
For Tunnel refer to "43.3.10 Tunnel -
•
Info Page - TS".
Description
When this box is checked, angles and stake-
out values are updated after a distance
measurement. All values are then frozen until
the next distance is taken. When Aim at tar-
get: With lock is selected and the instru-
ment is locked onto a target the angular val-
ues do not change.
When this box is not checked, angles are
updated with telescope movement after a
distance was measured.
643