Leica Captivate Technical Reference Manual page 874

Settings,
Advanced page
874
For Setup method: Resection and Setup method: Multiple backsights, the
settings on this page apply.
Description of fields
Field Option
Automati- Check box
cally turn TS
to next tar-
get point
Measure Check box
target
points while
measuring
other points
(on-the-fly)
Calculate & Check box
show scale
from the
measure-
ments made
to targets
For resec- Check box
tions use
Helmert
method for
calculations
Height 1/distance
weighting or 1/
distance²
Edit the Check box
default
setup limits
Orientation Editable field
limit
Position Editable field
limit
Height limit Editable field
Description
When this box is checked, the instrument
positions horizontally and vertically to the
point.
When this box is checked, the setup points
can be measured together with the survey
points. It is not necessary to complete the
setup before measuring survey points. Until
you select Set in Setup Results, this type
of setup is regarded as incomplete.
Only available if Scale TS measurements is
unchecked in the job properties TS scale
page.
If checked, a setup scale is calculated from
the target observations. You can apply this
new scale (calculated ppm + current ppm =
new ppm) to all survey observations, includ-
ing the setup observations, from that setup.
If not checked, then the calculated ppm is
not displayed and therefore not applied to
any survey observations.
Helmert calculation is used.
Available when For resections use Helmert
method for calculations is checked. To
change the distance weighting that is used in
the calculation of the setup height in the
resection.
Check to type in values for standard devia-
tion, position and height accuracy. If the lim-
its are exceeded, a message is shown when
Calculate is selected.
Available when Edit the default setup lim-
its is checked. Define a limit for the standard
deviation of the orientation.
Available when Edit the default setup lim-
its is checked. Define a position accuracy of
the target point.
Available when Edit the default setup lim-
its is checked. Define a height accuracy of
the target point.
Setup - TS