Leica Captivate Technical Reference Manual page 145

Settings for Fbk
Export,
General page
Job Menu - Export data
Description of fields
Field Option
Job Selectable list
Export for- Autodesk
mat FBK, TDS
RW5, TDS
RAW, Carl-
son RW5,
MicroSurvey
RW5 or
Bentley
RWD
To device Selectable list
To folder Display only
Output file Editable field
Next step
Fn Settings to access the setting panel.
Description of fields
Field Option
Use numeri- Check box
cal point ID
Point ID off- Editable field
set
Use angle Check box
right
Split meas- Check box
urements
and figures
Figure ID
Point code
Description
To select the job to export.
Ensure that this field is set properly.
Defines where the exported data are saved
to.
The data can be exported to the \DATA direc-
tory or to the folder where the export job is
located.
Default is the name of the selected Job. It
can be changed.
☞
The extension designation
(.FBK, .RW5, .RAW or RWD) is
added automatically.
Description
Available unless Export format: TDS RW5.
Available when Use numerical point ID is
checked.
The point IDs are offset by this value.
Define if angle right values are exported.
When this box is checked, TS linework is shif-
ted after the measurements. This setting
supports cases where the line is edited or
reversed.
Available for Export format: Autodesk FBK,
Export format: Carlson RW5 and Export
format: MicroSurvey RW5.
The name that will be assigned to the figure
or linework geometry in the CAD program.
The point code is used as ID.
145