Table of Contents
Advertisement
Lines
☞
Roads - Road
The panel can have several pages.
Lines page, if a design job is selected.
•
•
Alignments page (if road alignment is selected)
3D viewer page
•
If no working chainage has been entered, the lists show all lines of the current
layer. If a working chainage is available, all lines existing at that chainage are
listed only.
Key
Description
OK
To return to the previous panel.
More
On the Lines page: To display information about the codes if
stored with any line, the start time, the end time of when
the last point was added to the line and the length of the
line.
On the Alignments page: To display information about the
absolute height or the height difference. Unavailable for local
lines.
Page
To change to another page on this panel.
Description of metadata
Metadata
Description
-
The name of the line.
CL offset
The offset from the centreline. The format is defined as sys-
tem setting in Regional.
Height
The absolute height of the line.
Height diff
The height difference to the centreline.
In addition to the list selection the required lines and slopes can also be selec-
ted in 3D viewer.
Lines can be selected in a graphical way by using the
cross section view. The cross section view is available if a working chainage
•
has been defined. The selected line (3D only) from the design job is also
displayed. Unavailable for Stake: Local manual slope.
planar view which is always available. The defined working chainage is dis-
•
played as a grey line. The size corresponds to the working corridor set-
tings.
Click a line for selection.
747
Advertisement
Table of Contents
