Accessing Remote Point - Leica Captivate Technical Reference Manual

Diagram
☞
Averaging of remote
points
Coding of remote
points
37.4.2
Description
Measure Remote
Point,
Remote points page
434
d1
P0
TS_043
To ensure correct results, the remote point and the prism must be lined up ver-
tically. If it is not possible to maintain an exactly vertical line, the acceptable
Horizontal distance tolerance must be chosen. The horizontal distance to
the remote point and to the base point should coincide.
An average can be calculated for remote points if a measured point of class
Measured already exists with the same point ID. The average flag for the point
is Auto.
Type Description
Point coding Available in Remote points.
Free coding Free coding of remote points is identical to coding of man-
ually measured points.
Quick coding Not available.

Accessing Remote Point

Select Measure remote points from the toolbox. A valid distance measure-
ment must be available.
Key Description
Store Stores the remote point. Stays in this panel.
Base pt Returns to Measure. The distance measurement is cleared.
Fn Settings To configure hidden point measurements. Refer to "37.4.3
Configuring Remote Point".
a
P2
P0 Instrument setup
P1 Base point
P2 Remote point
d1 Horizontal distance to the
P1
base point
Vertical angle between base
α
point and remote point
a Vertical axis from P1 to P2
Apps - The Toolbox