Table of Contents
Advertisement
42.9
Description
Diagram
Access step-by-step
☞
Surface Scan Set-
tings,
Define grid scan spac-
ing.
Reference Plane & Grid Scan
Grid Scan on Surface - TS
Grid Scan on Surface allows the measurement of a grid on any surface based
on an angular resolution (constant delta horizontal and delta vertical values).
No reference plane is required. The grid scan area can be either rectangular or
polygonal. Optionally, the boundary of the grid scan area can be measured.
Grid Scan on Surface can be run on instruments with the option "reflectorless
EDM" only.
TS_121
1.
In Plane & Grid Scan, select Grid scan on surface.
2.
Press OK.
3.
Choose between:
•
Rectangular area: Two opposite corner points define the grid
scan area. The area must be defined by pointing the instrument
to opposite corners of the area. Grid scan areas bigger than
180° are allowed.
Polygonal area: Three or more clockwise measured points
•
define the grid scan area. The polygonal grid scan area is calcua-
lated based on the sequence of the points. Grid scan areas big-
ger than 180° are allowed.
4.
Press OK.
Most steps are identical with the steps for Grid scan on plane. Refer to "42.8
Grid Scan on Plane - TS" for a description of the panels.
Key
Description
OK
To continue with the next panel.
Distance
Available when Define spacing by: Distances is selected.
To take a distance measurement to any surface. The meas-
ured value is displayed in the Horizontal distance field.
Known
P0 Setup
Unknown
Grid point coordinates
P0
615
Advertisement
Table of Contents
