Table of Contents
Advertisement
Graphic
Workflow
45.4.5
Availability
Description
45.4.6
Availability
Description
Roads - Road
b
Road_098
1.
Measure a point:
For TS:
Distance
For GS:
Measure and Stop
2.
Press Fn Tools to access the toolbox.
3.
Select Get current angle to alignment.
4.
At the defined chainage, the angle between the tangent direction
and the direction to the current position is calculated. This angle is
set as Offset angle for Use non-perpendicular offset on the
page.
5.
Continue with staking out using the calculated Stake chainage and
Offset angle values. These values are valid until new values are
defined manually or by using Get current angle to alignment.
Stake individual point
This menu function is available for the stake/check of lines and local lines.
To stake out points with known Easting, Northing and Height. Points can either
be selected from the job or manually typed in.
If a design job has been selected, a point from the design job can be selected.
When staking out/checking an individual point, the selected point is set in rela-
tion to the alignment and all line relevant values are calculated and displayed.
The Stake chainage and Offset of the Stake panel are calculated based on
the coordinates of the selected point.
☞
If the chosen point has no height the design height is used. If the
point has a height it is possible to use that one or continue working
with the design height.
COGO Road - Alignment info
This menu function is available for staking/checking a line/local line.
This function allows
c
a
Alignment
b
Defined chainage
a
c
Current position
Angle to alignment
α
769
Advertisement
Table of Contents
