Table of Contents
Advertisement
Requirements for
channel changing
☞
☞
☞
Access
Radio Channel
226
Case 2:
Set up as in case 1.
Two separate fixes for each point can be obtained, providing
redundancy for future least squares adjustment operations.
Case 3:
One real-time base and one real-time rover are being used.
If the signal is blocked due to radio interference, the channel
at the base and the rover can be changed in order to work
on a different frequency.
Type
Requirement
Pacific Crest
Contact a Pacific Crest dealer for the activation of channel
radio
changing.
A special licence might be required.
Satelline
Channel switch works with all Satel radios.
radio
Channel changing may contravene radio broadcasting regulations in certain
countries. Before operating with radios, check the regulations in force in the
working area.
The number of channels available and the frequency spacing between channels
depends on the radio used.
For some Satel radios the configuration can be done within Leica Captivate.
If you want to use channel changing, set RTK base ID in RTK Base Settings
(RTK 1)/RTK Base Settings (RTK 2), Data rates page to a different ID for
each base site when configuring the base real-time connection. By doing so,
the rover can recognise if the incoming real-time data after channel changing is
being received from a different base station or if the original base station is
using a new frequency. In the first case, the ambiguities are recomputed.
For RTK rover and TS:
In Connection Settings, highlight a connection which has a radio
•
attached. Control.
For RTK base:
•
In Base Connection Settings, highlight a connection which has a radio
attached. Control.
Key
Description
OK
To accept changes and return to the panel from where this
panel was accessed.
Scan
To provide information such as the station ID, latency and
the data format of incoming signals from base stations
broadcasting on the same radio channel. This information
can be used to select appropriate base stations to dial.
Settings
To edit the channel list of the active radio. In base mode, a
password is required for changing the radio settings.
Connections - All other connections,
Control Key
Advertisement
Table of Contents
