Lacp Port-Priority - Alaxala AX3640S Software Manual

lacp port-priority

Sets the port priority.
Syntax
To set or change information:
lacp port-priority <priority>
To delete information:
no lacp port-priority
Input mode
(config-if)
Parameters
<priority>
Specifies the port priority. The lower the value, the higher the priority.
When
on
This parameter is used with the
When
active
This parameter applies to port priority for the LACP protocol.
1. Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
0 to 65535
Default behavior
is set as the port priority.
128
Impact on communication
If you specify the port priority for an active port by setting
, communication is temporarily interrupted. If you specify port priority for active ports by
passive
setting
channel-group mode
functionality, and communication might temporarily stop.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. If you specify the
max-active-port
2. If you change <priority>, the status of the applicable port changes to
(communication interrupted).
Related commands
interface gigabitethernet
interface tengigabitethernet
channel-group mode
is specified for the
channel-group mode
or is set for the
passive
to , ports that are use might be changed by the standby link
on
max-active-port
for the destination device.
command
command to select the standby links.
max-active-port
channel-group mode
channel-group mode
command, match its settings to the settings of
10. Link Aggregation
command
to
active
Blocking
or
149