Configuring The Pbx Via An Internal S Port (Ppp Internal) - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Service and Maintenance
Remote Configuration and Alternative Connection Options
Configuring the PBX via an Internal S
Important: An internal network is usually protected from actions from the
outside by, for example, a firewall integrated in the router. For questions
about configuring your firewall, contact the system administrator responsible
for this topic.
1. Start a browser (for example, Mozilla Firefox).
2. Enter http:// and the external IP address for the PBX as well as the : character. and
then the port into the address field of the browser.
The login window opens.
3. Enter your user name and PIN.
4. Click Log in.
The configuration manager opens.
5. Make the desired changes.
Configuring the PBX via an Internal S
Important: Before you can configure the PBX remotely via a dial-up
connection, the required configurations must first be made via an internal
network connection.
Requirements:
– Internal S port (only provided on the COMpact S
0
available as an option)
– Configured internal CAPI dial-in number
– Configured local and remote IP addresses
– Knowledge of the sub-admin PIN or admin PIN
Note: The external PIN may also be used for the dial-up connection. The user
PIN can also be used to log in.
– An existing internal ISDN connection between the PC and the PBX over an Auerswald USB
device (e.g., COMfortel 2500) or an ISDN PC controller including the complete installation of
the drivers required for the device on the PC
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
Port (PPP Internal)
0
Port (PPP Internal)
0
module or COMpact ISDN module
0
515