Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 450

Configuring and Managing the PBX
Call Distribution
Creating Call Distribution
Creating Call Distribution on the Analog Connection via the Internal Telephones
Requirements:
– Knowledge of the sub-admin or admin PIN
Note: If devices that automatically accept calls are connected
(e.g., answering machine, fax, analog door module), you need to remove
them before carrying out the configuration. Exception: Devices connected to
the fourth telephone jack.
1. Pick up the receiver of the internal telephone on which external calls should ring.
2. Dial ##8.
3. Enter the sub-admin or admin PIN.
4. Dial *901# and do not hang up the receiver.
Any other telephones connected also ring. The fourth telephone jack is meant for the
fax. The device connected does not ring.
5. Pick up the receivers of the telephones that are also supposed to ring for external
calls.
You will hear the confirmation tone on each receiver you pick up (pulsating tone).
Note: If a telephone is connected to the fourth telephone jack, instead of the
pre-configured fax machine, you must also pick up that receiver for just a
short time in order to cancel the default setting.
6. Hang up the receivers of all the telephones in order to complete the learning process
for this MSN.
Creating Call Distribution on the Point-to-Multipoint Connection via the Internal
Telephones
Requirements:
– Knowledge of the sub-admin or admin PIN
Note: If devices that automatically accept calls are connected
(e.g., answering machine, fax, analog door module), you need to remove
them before carrying out the configuration. Exception: Devices connected to
the fourth telephone jack.
450
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11