Copying A Function Key Assignment Into Other Mobile Handsets - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Managing the PBX
DECT System Telephones

Copying a Function Key Assignment into Other Mobile Handsets

Up to 24 digits
Digits and the characters * and #
UserPIN: Requires user PIN to be entered
IdentNumber: Requires the identification number to be entered
SC: Requires a short-code dialling number or external telephone number to be
entered
MSN, MSN/DDI: Requires your own external telephone numbers to be entered
Telephone number: Requires an external telephone number to be entered
Subscriber: Requires an internal subscriber telephone number to be entered
Subscriber/group: Requires an internal subscriber telephone number/internal
telephone number of a line group to be entered
Note: The character strings for the programming functions are listed in this
manual under "Configuring and Operating Functions".
8. Repeat step 5 to 7 to assign the function key with additional PBX functions.
9. Repeat step 4 to 7 to configure the function key for an additional mobile handset.
Note: The function key of a mobile handset can be copied into other mobile
handsets (Copy COMfortel DECT 900).
Further steps:
– Save your settings before you leave the page.
Note: The PBX begins to distribute the data to the mobile handsets in
question. If a mobile handset is currently not ready for the data transfer
(disabled, out of range or busy with a call), the PBX makes an attempt with
the next mobile handset after a few minutes until all of the data is distributed.
During the data transfer (duration: up to two minutes), the mobile handset is
not available and "Copying from PBX" is shown on the display.
Copying a Function Key Assignment into Other Mobile Handsets
The assignment of the
another mobile handset.
442
function key on a COMfortel DECT 900 Handset can be copied into
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11