Exchange Line Transfer; Exchange Line Transfer Sequence; Configuring An Exchange Line Transfer - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Operating Functions

Exchange Line Transfer

Exchange Line Transfer Sequence

Exchange Line Transfer
A suitably authorised system telephone, for example, the telephone exchange, can transfer the
exchange line access required for an outgoing call to another internal telephone for a short
period of time. This is meaningful, for example, when this telephone is located in a publicly
accessible room and is only occasionally used for external calls by an employee.
Exchange Line Transfer Sequence
The exchange line transfer proceeds as follows:
• The requesting telephone must initiate an internal call using the system telephone autho-
rized to make the exchange in order to request exchange line access.
• After the function key assigned to exchange line transfer has been pressed on the system
telephone authorized for making exchanges, a confirmation tone is issued to both internal
subscribers and the internal call must be ended.
• The requesting telephone now has access to the exchange line settings configured for this
purpose. These exchange line settings remain until the first successful, outgoing external
call or until the time limitation has elapsed for initiating the external call.

Configuring an Exchange Line Transfer

Requirements:
– System telephone COMfortel 1100/1500/2500/2500 AB/VoIP 2500 AB
– Internal S port (only available on the optional COMpact S
0
module) or internal VoIP channels (COMpact 3000 VoIP or VoIP channels acquired in the
Upgrade Center and released)
1. Configure a function key for the exchange line transfer on the system telephone
COMfortel 1100/1500/2500/2500 AB/VoIP 2500 AB.
2. Enable the authorization Transfer of external calls externally for the transferred
telephone.
3. At minimum, configure the business exchange line authorization Only inbound, with
emergency call for the requesting telephone.
240
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
module or COMpact ISDN
0