Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 493

Service and Maintenance
Status Displays
Status Displays on the LEDs
"LAN" LED:
Off
Lit in green
Flashes green
"Power" LED:
Lit in red
Lit in orange
Flashes orange
Lit in orange
Lit in green
"Power" LED:
Off
Flashes red (1/1 s)
Note: If the "Power" LED remains constantly lit even after a restart, an error
has occurred. Please contact your dealer or the manufacturer directly.
"Power" LED:
Flashes red quickly (50/
50 ms)
Flashes red slowly (0.5/
0.5 s)
Flashes red (0.05/1 s)
Lit in red
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
Status of the Ethernet interface (COMpact 3000 VoIP with
two Ethernet ports LAN):
No Ethernet connection to a computer/network exists.
An Ethernet connection to a computer/network exists.
(COMpact 3000 VoIP: there is a connection on at least one
port).
An Ethernet connection exists and packets are being trans-
mitted (COMpact 3000 VoIP: packets are being transmitted on
at least one port).
PBX status (after restart):
The boot partition is being tested.
The hardware data and the kernel are being loaded from the
partition.
The kernel drivers are being loaded.
The PBX application is being started.
The PBX is ready for operation.
Status on the PBX (in the case of an error):
No power supply is present.
No valid boot partition was found. System is paused.
Menu prompt (after pressing the "Default" button):
Pressing the "Default" button is detected.
The "Default" button was pressed for more than 5 seconds.
Releasing the button starts the update image.
The "Default" button was pressed for more than 10 seconds;
releasing the button restores the factory settings.
The "Default" button was pressed for more than 15 seconds; the
PBX restarts without changes.
493