Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions page 78

Using the Configuration Manager
Configuration Manager
Opening the Configuration Manager
Opening the Configuration Manager as a User
Requirements:
– An existing Ethernet connection between the PC and the PBX or both the PC and the PBX
on the same network
– Knowledge of the IP address on the PBX
– Configured user PIN
Note: If the UPnP service is installed and enabled on the PC being used, the
PBX is identified and selected as the "Auerswald PBX" device in the network
environment. The configuration manager is then opened in the browser.
Steps 1 and 2 are omitted. Proceed with Step 3.
1. Start a browser (for example, Mozilla Firefox or Microsoft Internet Explorer).
2. Enter the IP address of the PBX in the address field of the browser (for example,
http://192.168.178.4).
3. Enter the internal telephone number of the user under User name.
4. Enter the associated user PIN under PIN.
5. Click Log-in.
The configuration manager opens.
Further steps:
– Configure the desired settings in sequence (page for page).
Opening the Configuration Manager as a Sub-administrator
Requirements:
– An existing Ethernet connection between the PC and the PBX or both the PC and the PBX
on the same network
– Knowledge of the IP address on the PBX
– A configured sub-admin PIN
Note: If the UPnP service is installed and enabled on the PC being used, the
PBX is identified and selected as the "Auerswald PBX" device in the network
78
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11