Configuring The Remote Switching Number - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Operating Functions
Room Monitoring

Configuring the Remote Switching Number

Note: If, at this point, you hear a busy tone instead of a confirmation tone, the
new PIN may already be in use in the PBX and no change takes place. Re-
attempt with another digit sequence.
Configuring the Remote Switching Number
The remote switching number is one of the telephone numbers available on one's own
connection and is used to carry out the following tasks via the PBX:
• Perform a configuration switchover manually via an external telephone
• Monitor a room via an external telephone
In addition, the remote switching number is used as a dial-up phone number for a dial-up
connection. This is used to configure the PBX remotely via an external ISDN connection.
Note: If no remote switching number has been configured, the PBX must be
activated for remote configuration using a digit sequence on an internal
telephone. After this, the PBX is accessible over each associated MSN/DDI.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
– Expert view (click
– Configured external telephone numbers
1. Open the page SERVICE > Remote configuration.
2. Select the telephone number you want from the Remote switching number list field
under Remote configuration (PPP) and remote programming.
Note: This telephone number may not be rerouted using call forwarding.
Further steps:
– Save your settings before you leave the page.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
)
299